![]() In this case, the first command is taught in with "Assign", the second is assigned to the same button with "Assign Toggle".īeware of possible interference from monitors, bright lighting, fluorescent lamps or direct sunlight. Toggle: Some remote controls send two commands with a single button press. Repeat this procedure for all desired buttons. The IR command has now been assigned to the button of the respective remote control. ![]() Highlight the line, enter the name of the remote control and the button, and then click Assign. If several lines appear for the same button, select the one with the highest number. For each button press it increases by one. If you now repeatedly press the desired button on the remote control, the signal is displayed in the IR Monitor Learn. The IR Control Air indicates that it is ready to learn IR commands by flashing orange/green. Please read and confirm the information displayed in the window. Select the IR Control Air in the peripheral tree and then click on "Learn button". Pair remote control: If there is no template for the remote control, it must be paired manually. Insert template: In Loxone Config some remote controls are already available as templates. First, remote controls or commands must be defined. To activate the pairing mode manually, hold down the pairing button for at least 5 seconds after establishing power supply.Īfter pairing, the IR Control Air is available in Loxone Config. This is indicated by the status LED flashing red/green/orange. In delivery state, pairing mode will be active after the power supply has been established. Place the IR transmitter diodes close to the devices you want to controlĬonnect the supplied Micro USB power adapter to the back of the unit. Use the supplied Velcro tape to install the device near the devices you want to control.Ĭonnect the supplied IR receiver and IR transmitter to the back of the unit if required Up to four external IR transmitter diodes can be placed directly on your devices.īang & Olufsen and Daikin remote controls are not compatible with IR Control Air.ĭatasheet IR Control Air Table of Contents In addition to the internal IR transmitter and receiver, a wired external IR receiver allows the hidden placement of the IR Control Air. The Loxone IR Control Air can be used to control infrared-capable devices such as TVs, AV receivers, projectors, air conditioners etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |